800G OSFP Finned Top to 4× 200G OSFP Finned Top InfiniBand NDR Active Copper Breakout Cable

P/N: O800-4O-NDR-AC SKU: 30307

US$990.00

In Stock: 60 pcs

Cable Length Options

  • 1.7W @ 800GLow-power operation
  • 0.3W @ 200GLow-power operation
  • 800G-to-4×200GFlexible fan-out
  • Redriver CompensationImproves signal integrity
  • 8×100G PAM4High-speed signaling
  • 23mm Bend RadiusEasy cable routing
Compatible Brands: MSA Standard NVIDIA(InfiniBand)
Quantity: 1
In Stock: 60 pcs
  • 30-day return and refund service icon 30-day return and refund
  • 3-year warranty service icon 3-year warranty
  • available for delivery within 2 days service icon Available for delivery within 2 days
  • free shipping for qualifying orders service icon Free shipping for orders over

Specifications

Connector Type OSFP(Finned Top) to 4x OSFP(Flat Top) Data Rate 850Gbps to 4x 212.5Gbps
Media Copper Cable Type ACC
Cable Length 3m~5m(10ft~16ft) Outer Diameter 3m@AWG 30 4m~5m@AWG 26
Jacket Material PVC Minimum Bend Radius 23mm@AWG 30 32.5mm@AWG 26
Power Consumption ≤1.7W @800G ≤0.3W @200G Case Operating Temperature 0 to 70°C (32 to 158°F)
Protocol 4x 200G Breakout Ethernet 4x 200G RoCE 4x 200G Infiniband NDR200 Application Switch to NIC

Applications

Certification

Features

Switch Series & Supported Models

Browse common switch series and models supported for each brand.

Resources

FAQ

Find answers to common product questions, or ask our technical team.

Does each 200G branch work independently?

Yes. After breakout is configured on the host side, each branch is recognized as a separate 200G logical link. The four branches do not share one single 200G channel.

Is this ACC the same as an AEC cable?

No. ACC mainly uses active equalization, while AEC typically provides stronger signal processing such as retiming. ACC is a good choice when you need a longer copper reach with low latency and lower power than a retimed solution.

Does the active design increase power consumption?

Yes, it uses more power than a passive DAC because of the built-in equalizer. Typical power consumption is about 1.7W at the 800G end and about 0.3W per 200G branch end.

What should I pay attention to when routing this cable?

Because this is a 1-to-4 copper breakout cable with OSFP ends, enough space should be reserved for branch routing and bend radius. Avoid sharp bends or pulling stress near the OSFP connectors during installation.

Customer Reviews

Write a Review
4.5 Based on 3 reviews
D***e Verified Purchase

Delivery was really fast, and we appreciated that. We needed extra cables at the last minute, and AICPLIGHT didn’t hold up our installation window.

Was this review helpful?
R***k Verified Purchase

We used it for a short cross-rack run, and the length worked well. The cable is a bit stiff, so leaving extra bend room makes the routing easier.

Was this review helpful?
L***y Verified Purchase

The labels on both ends were clear, so the onsite team didn’t mix anything up. Small detail, but it matters when you’re wiring multiple ports.

Was this review helpful?